[Nov 17, 2021] Fully Updated CCNP Enterprise (300-410) Certification Sample Questions
Latest Cisco 300-410 Real Exam Dumps PDF
What Job Opportunities Await Those Certified?
As long as the Cisco CCNP Enterprise is one of the most rewarding certifications out there for computer networking professionals, earning it is a huge plus point that immediately highlights a job-seeker from the rest of the crowd. Being CCNP Enterprise accredited is not only about having a nice certificate to hang on your wall or link in your LinkedIn profile for the world to see. It is also about how competent you have become in performing the more serious, harder tasks of networking that put a company's entire networking infrastructure on your shoulders.
NEW QUESTION 53
Refer to the exhibit.
A network engineer for AS64512 must remove the inbound and outbound traffic from link A during maintenance without closing the BGP session so that there is still a backup link over link A toward the ASN. Which BGP configuration on R1 accomplishes this goal?
A)
B)
C)
D)
- A. Option B
- B. Option C
- C. Option A
- D. Option D
Answer: D
NEW QUESTION 54
Refer to the exhibit.
An engineer is trying to block the route to 192.168.2.2 from the routing table by using the configuration that is shown. The route is still present in the routing table as an OSPF route. Which action blocks the route?
- A. Use an extended access list instead of a standard access list.
- B. Change sequence 10 in the route-map command from permit to deny.
- C. Add this statement to the route map: route-map RM-OSPF-DL deny 20.
- D. Use a prefix list instead of an access list in the route map.
Answer: B
NEW QUESTION 55 
Refer to the exhibits. An engineer filtered messages based on severity to minimize log messages. After applying the filter, the engineer noticed that it filtered required messages as well. Which action must the engineer take to resolve the issue?
- A. Configure syslog level 3.
- B. Configure syslog level 5.
- C. Configure syslog level 2.
- D. Configure syslog level 4.
Answer: B
NEW QUESTION 56
Drag and drop the SNMP attributes in Cisco IOS devices from the left onto the correct SNMPv2c or SNMPV3 categories on the right.
Answer:
Explanation:
NEW QUESTION 57
Refer to the exhibit.
An engineer is trying to redistribute OSPF to BGP, but not all of the routes are redistributed.
What is the reason for this issue?
- A. BGP convergence is slow, so the route will eventually be present in the BGP table.
- B. By default, only internal OSPF routes are redistributed into BGP
- C. Only classful networks are redistributed from OSPF to BGP.
- D. By default, only internal routers and external type 1 routes are redistributed into BGP.
Answer: B
NEW QUESTION 58
Refer to the exhibit.
An engineer wanted to set a tag of 30 to route 10 1.80.65/32 but it failed How is the issue fixed?
- A. Modify route-map ospf-to-eigrp permit 30 and match prefix-list ccnp2.
- B. Modify prefix-list ccnp3 to add 10.1.64.0/20 ge 32
- C. Modify prefix-list ccnp3 to add 10.1.64.0/20 le 24
- D. Modify route-map ospf-to-eigrp permit 10 and match prefix-list ccnp2.
Answer: D
NEW QUESTION 59
What are two purposes of using IPv4 and VPNv4 address-family configurations in a Layer 3 MPLS VPN? (Choose two.)
- A. MP-BGP is used to allow overlapping IPv4 addresses between customers to advertise through the network.
- B. The VPNv4 address consists of a 64-bit route distinguisher that is prepended to the IPv4 prefix.
- C. The IPv4 address is needed to tag the MPLS label.
- D. RD is prepended to the IPv4 route to make it unique.
- E. The VPNv4 address is used to advertise the MPLS VPN label.
Answer: A,B
NEW QUESTION 60
Refer to the exhibit.
What does the imp-null tag represent in the MPLS VPN cloud?
- A. Pop the label
- B. Include the EXP bit
- C. Impose the label
- D. Exclude the EXP bit
Answer: A
Explanation:
Explanation
The imp-null (implicit null) tag instructs the upstream router to pop the tag entry off the tag stack before forwarding the packet.
Note: pop means remove the top MPLS label
NEW QUESTION 61
Refer to the exhibit.
In which circumstance does the BGP neighbor remain in the idle condition?
- A. if a prefix list is applied on the inbound direction
- B. if prefixes reach the maximum limit
- C. if prefixes are not received from the BGP peer
- D. if prefixes exceed the maximum limit
Answer: D
Explanation:
Explanation
https://www.cisco.com/c/en/us/support/docs/ip/border-gateway-protocol-bgp/25160-bgp-maximum-prefix.html#
NEW QUESTION 62
Drag and drop the addresses from the left onto the correct IPv6 filter purposes on the right.
Answer:
Explanation:
Explanation:
HTTP and HTTPs run on TCP port 80 and 443, respectively and we have to remember them.
Syslog runs on UDP port 514 while NTP runs on UDP port 123 so if we remember them we can find out the matching answers easily. But maybe there is some typos in this question as 2001:d88:800:200c::c/126 only ranges from 2001:d88:800:200c:0:0:0:c to 2001:d88:800:200c:0:0:0:f (4 hosts in total). It does not cover host 2001:0D88:0800:200c::1f. Same for 2001:D88:800:200c::e/126, which also ranges from 2001:d88:800:200c:0:0:0:c to 2001:d88:800:200c:0:0:0:f and does not cover host 2001:0D88:0800:200c::1c.
NEW QUESTION 63
Drag and drop the packet types from the left onto the correct descriptions on the right.
Answer:
Explanation:
NEW QUESTION 64
Which command allows traffic to load-balance in an MPLS Layer 3 VPN configuration?
- A. multi-paths eibgp 2
- B. maximum-paths 2
- C. Maximum-paths ibgp 2
- D. multi-paths 2
Answer: C
Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/5_x/nx-os/mpls/configuration/guide/mpls_cg/mp_vpn_multipath.html
NEW QUESTION 65
An engineer configured a Cisco router to send reliable and encrypted notifications for any events to the management server. It was noticed that the notification messages are reliable but not encrypted. Which action resolves the issue?
- A. Configure all devices for SNMPv3 traps with auth.
- B. Configure all devices for SNMPv3 traps with priv.
- C. Configure all devices for SNMPv3 informs with priv.
- D. Configure all devices for SNMPv3 informs with auth.
Answer: B
NEW QUESTION 66
Drag and drop the SNMP attributes in Cisco IOS devices from the left onto the correct SNMPv2c or SNMPV3 categories on the right.
Answer:
Explanation:
NEW QUESTION 67
Drag and drop the MPLS terms from the left onto the correct definitions on the right.
Answer:
Explanation:
NEW QUESTION 68
Refer to the exhibits. An engineer filtered messages based on severity to minimize log messages. After applying the filter, the engineer noticed that it filtered required messages as well. Which action must the engineer take to resolve the issue?
- A. Configure syslog level 5.
- B. Configure syslog level 3.
- C. Configure syslog level 2.
- D. Configure syslog level 4.
Answer: B
NEW QUESTION 69
Refer to the exhibit.
During troubleshooting it was discovered that the device is not reachable using a secure web browser. What is needed to fix the problem?
- A. permit tcp port 465.
- B. permit tcp port 443
- C. permit udp port 465
- D. permit tcp port 22
Answer: B
NEW QUESTION 70
Refer to the exhibit.
An engineer is trying to redistribute OSPF to BGP, but not all of the routes are redistributed. What is the reason for this issue?
- A. By default, only internal OSPF routes are redistributed into BGP
- B. Only classful networks are redistributed from OSPF to BGP
- C. BGP convergence is slow, so the route will eventually be present in the BGP table
- D. By default, only internal routes and external type 1 routes are redistributed into BGP
Answer: A
NEW QUESTION 71
......
Details of Cisco 300-410 Exam
Cisco 300-410 is a 90-minute exam, and the applicants are required to answer about 65 questions during this allocated time. These items can be presented in different formats, including multiple choice, testlets, drag and drop, or fill-in-the-blank. To earn the certification, the candidates have to gain the passing score of a minimum of 750 points on a scale of 1000. Please keep in mind that this test can be only taken in the Japanese and English languages. Also, the learners must pay the fee of $300. This payment allows them to register and schedule the exam through the Pearson VUE platform. After that, the students can choose the proper way of the delivery of this test. If you want to sit for this exam at the testing center, you can choose an in-person variant. On the other hand, you can opt for the online testing that will give you an opportunity to take the exam from any place at any time. Those individuals who do not achieve the pass mark will be asked to retake the 300-410 ENARSI test.
Cisco 300-410 Exam Topics:
| Section | Weight | Objectives |
|---|---|---|
| VPNTechnologies | 20% | 1.Describe MPLS operations (LSR, LDP, label switching, LSP) 2.Describe MPLS Layer 3 VPN 3.Configure and verify DMVPN (single hub)
|
| Layer 3 Technologies | 35% | 1.Troubleshoot administrative distance (all routing protocols) 2.Troubleshoot route map for any routing protocol (attributes, tagging, filtering) 3.Troubleshoot loop prevention mechanisms (filtering, tagging, split horizon, route poisoning) 4.Troubleshoot redistribution between any routing protocols or routing sources 5.Troubleshoot manual and auto-summarization with any routing protocol 6.Configure and verify policy-based routing 7.Configure and verify VRF-Lite 8.Describe Bidirectional Forwarding Detection 9.Troubleshoot EIGRP (classic and named mode)
10.Troubleshoot OSPF (v2/v3)
- Path preference
|
| Infrastructure Services | 25% | 1.Troubleshoot device management
2.Troubleshoot SNMP (v2c, v3) |
| Infrastructure Security | 20% | 1.Troubleshoot device security using IOS AAA (TACACS+, RADIUS, local database) 2.Troubleshoot router security features
3.Troubleshoot control plane policing (CoPP) (Telnet, SSH, HTTP(S), SNMP, EIGRP, OSPF, BGP) |
Cisco 300-410 Dumps - Secret To Pass in First Attempt: https://www.passtestking.com/Cisco/300-410-practice-exam-dumps.html
300-410 Practice Test Questions Updated 240 Questions: https://drive.google.com/open?id=1W5P2rkDFWHvsHzISwTdFhv46l4HH16PM