HPE7-A01 by HP Actual Free Exam Q&As

Question 1

How Multicast Transmission Optimization implemented in an HPE Aruba Networking wireless network?

A. The optimal rate for sending multicast frames is based on the highest broadcast rate across all associated clients B. The optimal rate for sending multicast frames is based on the lowest broadcast rate across all associated clients. C. The optimal rate for sending multicast frames is based on the lowest unicast rate across all associated clients. D. When this option is enabled the minimum default rate for multicast traffic is set to 12 Mbps for 5 GHz

Discussion 0

Correct Answer: C Vote an answer

Explanation: Only visible for PassTestking members. You can sign-up / login (it's free).

Question 2

You need to ensure that voice traffic sent through an AOS-CX arrives with minimal latency.
What is the best scheduling mechanism to use for this task?

A. DWRR queuing B. Strict queuing C. Rate limiting D. QoS shaping

Discussion 0

Correct Answer: B Vote an answer

Explanation: Only visible for PassTestking members. You can sign-up / login (it's free).

Question 3

How do you allow a new VLAN 200 for downstream access switch with VSX pair using VSX LAG?

A. vlan trunk add 100 in LAG1 multi-chassis B. vlan trunk add 100 in MLAG1 C. vlan trunk allowed all in LAG 1 multi-chassis D. vlan trunk allowed 200 in MLAG 1

Discussion 0

Correct Answer: D Vote an answer

Explanation: Only visible for PassTestking members. You can sign-up / login (it's free).

Question 4

When configuring UBT on a switch what will happen when a gateway role is not specified?

A. The switch will assign the default deny role to the client. B. The gateway will send back the deny role to the client. C. The switch will put the client on the access VLAN D. The gateway will assign a default role to the client

Discussion 0

Correct Answer: C Vote an answer

Explanation: Only visible for PassTestking members. You can sign-up / login (it's free).

Question 5

When setting up an AOS-CX VSX pair, which information does the Inter-Switch Protocol synchronize in the configuration created?

A. UDLD B. LACP C. RPVST+ D. SVI

Discussion 0

Correct Answer: B Vote an answer

Explanation: Only visible for PassTestking members. You can sign-up / login (it's free).

Question 6

Your manufacturing client is having installers deploy seventy headless scanners and fifty IP cameras in their warehouse. These new devices do not support 802.1X authentication.
How can HPE Aruba Networking reduce the IT administration overhead associated with this deployment while maintaining a secure environment using MPSK?

A. Pre-define the unique pre-shared keys in HPE Aruba Networking Central before deployment. B. Have the installers generate keys with HPE Aruba Networking ClearPass Self Service Registration. C. MPSK Local will allow the cameras to share a key and the scanners to share a different key. D. Use MPSK Local to automatically provide unique pre-shared keys for devices.

Discussion 0

Correct Answer: D Vote an answer

Explanation: Only visible for PassTestking members. You can sign-up / login (it's free).

Question 7

Your customer currently has Iwo (2) 5406 modular switches with MSTP configured as their core switches. You are proposing a new solution. What would you explain regarding the Aruba CX VSX switch pair when the Primary VSX node is replaced and the system MAC is replaced?

A. During the initial VSX configuration, the system-mac is assigned with a fixed MAC based on VSX ID. B. VSX will select the MAC address from a node that is a higher ID. C. VSX will select the MAC address from a node that is the lower ID. D. Configure vMAC on the Primary VSX node under VSX to retain MAC after hardware replacement.

Discussion 0

Correct Answer: A Vote an answer

Explanation: Only visible for PassTestking members. You can sign-up / login (it's free).

Question 8

Which feature allows the device to remain operational when a remote link failure occurs between a Gateway cluster and a RADIUS server that is either in the cloud or a datacenter?

A. Opportunistic key caching B. MAC Authentication C. Authentication survivability D. MAC caching

Discussion 0

Correct Answer: C Vote an answer

Explanation: Only visible for PassTestking members. You can sign-up / login (it's free).

Question 9

A customer just upgraded aggregation layer switches and noticed traffic dropping for 120 seconds after the aggregation layer came online again.
What is the best way to avoid having this traffic dropped given the topology below?

A. Configure the linkup delay timer to include LAGs 101 and 102, which will allow time for routing adjacencies lo form and to learn upstream routes B. Configure the linkup delay timer to exclude LAGS 101 and 102, which will allow time for routing adjacencies to form and to learn upstream routes C. Configure the linkup delay timer to 240 seconds to double the amount of lime for the initial phase to sync D. Configure the linkup delay timer to 120 seconds, which will allow the right amount of time for the initial phase to sync

Discussion 0

Correct Answer: A Vote an answer

Explanation: Only visible for PassTestking members. You can sign-up / login (it's free).

Question 10

A company with 10, 281 employees recently deployed new HPE Aruba Networking Access Points at different branch offices. Wireless 802.1X authentication will be against a RADIUS server in the cloud. The security team is concerned that the traffic between the AP and the RADIUS server will be exposed.
What is the appropriate solution for this scenario?

A. Configure RadSec on the AP and the RADIUS server B. Enable EAP-TLS on all wireless devices C. Enable EAP-TTLS on all wireless devices. D. Configure RadSec on the AP and Aruba Central.

Discussion 0

Correct Answer: A Vote an answer

Explanation: Only visible for PassTestking members. You can sign-up / login (it's free).

Question 11

A large retail client is looking to generate a rich set of contextual data based on the location information of wireless clients in their stores Which standard uses Round Trip Time (RTT) and Fine Time Measurements (FTM) to calculate the distance a client is from an AP?

A. 802.11be B. 802.11V C. 802.11mc D. 802.11ah

Discussion 0

Correct Answer: C Vote an answer

Explanation: Only visible for PassTestking members. You can sign-up / login (it's free).

HP Aruba Certified Campus Access Professional - HPE7-A01 Exam Practice Test