F5 BIG-IP LTM Specialist: Architect Set-Up & Deploy - 301a Exam Practice Test

An LTM Specialist needs to terminate client SSL traffic and based on the cookie presented by client.
Which set of profiles should the LTM Specialist use?

An LTM Specialist is configuring a new virtual server on an LTM device and assigning a SNAT pool that is already is use another virtual server. Both virtual servers use the same pool members to load balance traffic. A maximum of 35,000 users needs to be able to access each virtual server ta any time. The network architecture does NOT allow the backend servers to use the LTM device as a default gateway.
What is the minimum number of SNAT addresses required in the SNAT pool to meet the needs of the virtual servers?

A new DNS virtual server has been configured. Testing reveals that DNS server has failed to accept DNS over TCP.
The configuration of the virtual server is as follows:

Which action should be taken to correct this issue?

TWO LTM devices are in the same Device Group and configured for Ac live/Standby Failover.
The LTM Specialist observes that the HA Active and Standby device constantly changes state. All network links use the default route domain A dedicated fiber ink is used for the HA connection with a latency of 250 ms but no packet loss.
What is causing the change in failover state to occur?

An LTM Specialist needs to create two virtual servers. The application has links for both HTTP and HTTPS version of application. The client must be persistence to a pool member, no matter which virtual server is accessed.
What must be selected in the Source Address Affinity persistence profile?

An LTM device needs an additional traffic group.
Which configuration item is required?

An LTM Specialist needs to create a pool with a set of monitor that checks both the pool members and corresponding application service ports. The pool members have services on port
80. The application service is on port 8009.
The LTM device should load balance traffic to the pool member when the pool member and corresponding application service pass monitor.
Which monitor and parameter set meets this requirement?

An LTM device configuration is as shown

What should be the two expected outcomes based on this configuration? (Choose two.)

An LTM Specialist needs to configures virtual server that uses PVA or OPVA.
Which virtual server type should be used?

TWO BIG-IP appliances need to be configured to load balance multiple firewall in a firewall sandwich.
Which health monitor setting should be used to verify that the firewalls are able to forward traffic?

Which process can be eliminated by terminating SSL communication on the LTM device rather than the backend pool members?

Refer to the exhibit.

An LTM Specialist configures the two syslog destination Syslog destination #1 can receive messages but the syslog destination #2 can NOT receive messages.
Which command sill correct the issue?

What is required before adding a third device into an existing HA device group?