Cisco Designing Cisco Enterprise Networks - 300-420 Exam Practice Test

Refer to the exhibit. An engineer is designing an OSPF solution with these requirements:
- NMS server will manage R5 and R6.
- Upon failure of R1, all NMS traffic should be routed through R4.
- Upon failure of the link between R5 and R6, all traffic destined for
10.6.6.6 should be routed through R4.
Which solution must the engineer choose?

Refer to the exhibit. An engineer must design an address translation solution to provide internet connectivity for the corporate network. The design is restricted to the 172.16.168.0/22 subnet.
Which solution must the engineer choose?

Which two routing protocols allow for unequal cost load balancing? (Choose two.)

An engineer is creating a design to enable IPv6 to run on an existing IPv4 IS-IS network. The IPv4 and IPv6 topologies will match exactly, and the engineer plans to use the same router levels for each protocol per interface. Which IS-IS design is required?

A network engineer must segregate three interconnected campus networks using IS-IS routing.
A two-layer hierarchy must be used to support large routing domains and to avoid more specific routes from each campus network being advertised to other campus network routers automatically.
Which two actions does the engineer take to accomplish this segregation? (Choose two.)

An engineer must establish a direct connection between two remote offices. The new connection must be established using a logical path, share a common broadcast domain, connect over private WAN, and have as little overhead as possible. Which technology must the engineer choose?

How do endpoints inside an SD-Access network reach resources outside the fabric?

A company is planning to open two new branches and allocate the 2a01:c30:16:7009::3800/118 IPv6 network for the region. Each branch should have the capacity to accommodate maximum of
200 hosts. Which two networks should the company use? (Choose two.)

Which two options can you use to configure an EIGRP stub router? (Choose two)

A customer is discussing QoS requirements with a network consultant. The customer has specified that endto-end path verification is a requirement. Which QoS solution meets this requirement?

Drag and Drop Question
Drag and drop the properties from the left onto the protocols they describe on the right.

An architect must address sustained congestion on the access and distribution uplink of network.
QoS has already been implemented and optimized, but it is no longer effective in ensuring optimal network performance.
Which two solutions should the architect use to improver network performance? (Choose two)