A fully updated 2021 HPE0-J58 Exam Dumps exam guide from training expert PassTestking
Provides complete coverage of every objective on exam and exam preparation HPE0-J58
NEW QUESTION 21
A customer needs a data recovery solution for their HPE 3PAR array. They have the following requirements:
RPO needs to be within three hours
RTO needs to be within three hours
There is no need for offsite data archive
They will have a limited maintenance window
Which solution meets all of the customer needs?
- A. HPE StoreOnce
- B. HPE StoreAll
- C. HPE StoreEver
- D. HPE 3PAR StoreServ with RMC
Answer: D
NEW QUESTION 22
A customer has two sites. The link between sites is Fibre Channel, and the distance between sites is less than
1km. The link latencies are within HPE recommended tolerances.
The customer asks you to design a Peer Persistent solution using HPE servers running physical Windows
2016 servers and HPE 3PAR storage.
What are characteristics of the Quorum Witness? (Select two.)
- A. A Peer Persistence Quorum Witness is required for normal HPE 3PAR Peer Persistence operation
- B. A physical implementation of the Peer Persistence Quorum Witness is required on a third site
- C. Quorum Witness becomes relevant only during 3PAR Peer Persistence failover
- D. A virtual implementation of the Peer Persistence Quorum Witness is required on a third site
- E. The Quorum Witness initiates the fail-over, passing control to the standby array
Answer: A,D
NEW QUESTION 23
A customer has recently acquired another company that is located less than 3 km from their current main location. Both locations use HPE B-Series products in their storage environment.
The customer needs to merge the 2 locations together while still using the current WAN and networking infrastructure at both locations. They need to keep their initial cost down until they are able to redesign both networking infrastructures.
Which protocol should be incorporated when providing a proposal to meet the customer needs?
- A. CWDM
- B. ISCSI
- C. FCIP
- D. DWDM
Answer: A
NEW QUESTION 24
Refer to the Exhibit.
A customer with an existing HPE Nimble installation sends you the output shown. The administrator who initially set up the replication has left the company.
They ask you what the current RPO level for their replication is. How should you respond?
- A. They have an RPO of four minutes
- B. They have an RPO of two minutes
- C. They need to verify the RPO level from the host vc-ms-fileserver
- D. They need to send a screenshot of the volumes tab
Answer: A
NEW QUESTION 25
A customer has standardized on Windows Server. They need to ensure that application and storage will move between sites as one during automated or manual failover. Which HPE 3PAR integrated solution should you recommend to the customer as a preventative measure?
- A. Cluster Extension (CLX)
- B. Serviceguard Metrocluster
- C. Site Recovery Manager
- D. Peer Persistence
Answer: A
Explanation:
Explanation/Reference:
Reference: https://tdhpe.techdata.eu/Documents/TDAS-Integrated%20Systems/Technical%20White%
20Paper_HPE%20ConvergedSystem%20700.pdf?epslanguage=en
NEW QUESTION 26
A customer needs to replace their outdated storage arrays.
Which resource provides the necessary information to properly size a solution?
- A. HPE Storage Assessment Foundry
- B. HPE NinjaCrawler
- C. HPE Storage Sizer
- D. HPE Ninja Stars for Nimble
Answer: C
NEW QUESTION 27
A customer has two data centers in a metropolitan areA. The link between the data centers is IP-based and satisfies the bandwidth and latency requirements. They have the following requirements:
* Transparently and automatically failover and fall back between sites
* Provide block and file access
* Block access must provide connectivity for fibre channel and iSCSi hosts
* All-Flash storage solution
You plan to propose a design based on HPE 3PAR storage arrays.
What would be the most cost-effective model that meets the customer needs?
- A. HPE 3PAR 9450
- B. HPE 3PAR 8450
- C. HPE 3PAR 20450
- D. HPE 3PAR 20850
Answer: B
NEW QUESTION 28
A customer requests a proposal for two HPE 3PAR arrays using asynchronous periodic replication. The customer has two data centers, and the current bandwidth available for replication between the data centers is
200 Mb/s.
The customer is replicating 30TB, and the change rate is 3% in 24 hours. The customer wants to achieve an RPO of 10 minutes.
Which statement about bandwidth and replication is true for the customer requirements?
- A. The bandwidth will have to be increased, and replication must happen every 5 minutes
- B. The bandwidth is sufficient, and replication must happen every 10 minutes
- C. The bandwidth is sufficient, and replication must happen every 5 minutes
- D. The bandwidth will have to be increased, and replication must happen every 10 minutes
Answer: A
NEW QUESTION 29
A customer is expecting rapid growth of their data storage needs on their HPE Nimble arrays. Which HPE tool should you recommend to best assist with capacity planning?
- A. One Config Advanced
- B. InfoSight
- C. NinjaCrawler
- D. NinjaStars for Nimble
Answer: A
NEW QUESTION 30
A customer requests a proposal for two HPE 3PAR arrays using asynchronous periodic replication. The customer has two data centers, and the current bandwidth available for replication between the data centers is 200 Mb/s.
The customer is replicating 30TB, and the change rate is 3% in 24 hours. The customer wants to achieve an RPO of 10 minutes.
Which statement about bandwidth and replication is true for the customer requirements?
- A. The bandwidth will have to be increased, and replication must happen every 5 minutes
- B. The bandwidth is sufficient, and replication must happen every 10 minutes
- C. The bandwidth is sufficient, and replication must happen every 5 minutes
- D. The bandwidth will have to be increased, and replication must happen every 10 minutes
Answer: A
NEW QUESTION 31
A customer needs a data recovery solution for their HPE 3PAR array. They have the following requirements:
* RPO needs to be within three hours
* RTO needs to be within three hours
* There is no need for offsite data archive
* They will have a limited maintenance window
Which solution meets all of the customer needs?
- A. HPE StoreOnce
- B. HPE StoreAll
- C. HPE StoreEver
- D. HPE 3PAR StoreServ with RMC
Answer: D
NEW QUESTION 32
A customer has a requirement to provide disaster recovery for an application. The application has an RPO of
30 mins, with an RTO of 15 mins. How can HPE 3PAR Remote Copy help meet the customer's specified requirements in the most cost effective manner?
- A. by using Synchronous Replication
- B. by using Synchronous Long Distance Mode
- C. by using Streaming Asynchronous replication with an interval of 15 mins
- D. by using Periodic Asynchronous Replication with an interval of 15 mins
Answer: A
NEW QUESTION 33
A customer needs to analyze performance and capacity of their storage environment. Their environment consists of HPE 3PAR, EMC VNX, and Pure Systems.
Which tool should you use to begin your assessment of their environment?
- A. DD Analyzer
- B. HPE Infosight
- C. NinjaCrawler
- D. SAF Collect
Answer: C
NEW QUESTION 34
A customer has two HPE Nimble arrays that are replication partners. The customer suffers a complete outage on the source array. What does the administrator need to do to make the most recent snapshot available?
- A. Perform a handover between the arrays
- B. Promote the target snapshot
- C. Demote the source snapshot
- D. Verify the automatic failover occurred
Answer: A
NEW QUESTION 35
A customer requests a proposal for two HPE 3PAR arrays using asynchronous periodic replication. The customer has two data centers, and the current bandwidth available for replication between the data centers is
200 Mb/s.
The customer is replicating 30TB, and the change rate is 3% in 24 hours. The customer wants to achieve an RPO of 10 minutes.
Which statement about bandwidth and replication is true for the customer requirements?
- A. The bandwidth will have to be increased, and replication must happen every 5 minutes
- B. The bandwidth is sufficient, and replication must happen every 10 minutes
- C. The bandwidth is sufficient, and replication must happen every 5 minutes
- D. The bandwidth will have to be increased, and replication must happen every 10 minutes
Answer: A
Explanation:
Explanation
NEW QUESTION 36
An HPE Nimble customer needs to consolidate storage and scale performance. They are looking to purchase additional hardware to meet these requirements.
What is the best solution to offer this customer?
- A. Add additional HBAs in the arrays
- B. Use multiple single-array storage pools
- C. Use multi-array storage pools
- D. Add additional SSDs to the cache
Answer: B
NEW QUESTION 37
A customer needs to replicate the data on their HPE 3PAR arrays between their datacenters. Their datacenters are 250km apart. The link between the sites has an RTO of 100 ms, and they have an RPO of 3 minutes.
Which replication method should you recommend to meet the customer needs?
- A. RCFC is Synchronous mode
- B. RCIP in Asynchronous Streaming mode
- C. RCIP is Synchronous mode
- D. RCFC in Asynchronous Periodic Mode
Answer: D
NEW QUESTION 38
A customer is interested in using HPE InfoSight Cross-stack Analytics for VMware.
Where does the customer need to make the appropriate configuration changes to makes this active?
- A. HPE 3PAR SSMC
- B. VMware vCenter
- C. HPE InfoSight Portal
- D. HPE 3PAR Service Processor
Answer: C
NEW QUESTION 39
Refer to the exhibit, which reflects the Bill of Materials (BOM) configuration for one datacenter.
A customer needs a new storage solution of two HPE 3PAR 8440 arrays. The customer's environment consists of eight physical servers in each data center attached to the SAN and one StoreOnce 3540 system with two FC I/O cards. The distance between data centers is less than 75 meters.
What should you add the BOM to meet the customer needs?
- A. one HPE 3PAR StoreServ 8000 Direct Connect Cabling Option for Drive Enclosure for each HPE
3PAR 8440 - B. one HPE SN3000B SAN Switch 12-port Upgrade E-LTU per switch, appropriate number of SFPs and cables
- C. one HPR 3PAR StoreServ AC RPS Service Processor
- D. one HPE 25m Mini SAS High Density Active Optical Cable for each HPE 3PAR 8440
Answer: C
NEW QUESTION 40
......
Tested Material Used To HPE0-J58: https://www.passtestking.com/HP/HPE0-J58-practice-exam-dumps.html