NS0-014 by Network Appliance Actual Free Exam Q&As

Question 1

What are two core components of a MetroCluster IP architecture? (Select two)

A. ATTO FibreBridge B. Fibre Channel switches C. SyncMirror D. Inter-Switch Links (ISLs)

Discussion 0

Correct Answer: C,D Vote an answer

Question 2

Which tool confirms compatibility between a fabric-attached MetroCluster ONTAP software release and an FC switch firmware release?

A. Active IQ Config Advisor B. Active IQ Unified Manager C. ONTAP Mediator D. MetroCluster Tiebreaker software

Discussion 0

Correct Answer: A Vote an answer

Question 3

What are two key indicators of a successful switchover test in a MetroCluster environment?
(Select two)

A. The secondary site remains in read-only mode B. Replication traffic switches to the secondary site C. All data services remain available during the test D. Replication traffic switches to the secondary site

Discussion 0

Correct Answer: B,C Vote an answer

Question 4

Which tool is commonly used to assess MetroCluster prerequisites before installation?

A. OnCommand System Manager B. Active IQ Unified Manager C. Config Advisor D. StorageGRID

Discussion 0

Correct Answer: C Vote an answer

Question 5

In a MetroCluster environment, which two steps are required to configure FC switches? (Select two)

A. Set up inter-switch links (ISLs) between the FC switches B. Configure VSANs for all switches C. Configure IPsec for secure communication D. Enable NPIV (N-Port ID Virtualization)

Discussion 0

Correct Answer: A,D Vote an answer

Question 6

What are two methods to verify that MetroCluster replication is functioning properly? (Choose two)

A. Verify data consistency using SnapMirror B. Use the metrocluster check command C. Perform a data validation using Config Advisor D. Check IP route tables between sites

Discussion 0

Correct Answer: A,B Vote an answer

Question 7

When troubleshooting a site failure in MetroCluster, which log file provides detailed information about the failure event?

A. SyncMirror log B. Cluster log C. Tiebreaker log D. ONTAP Syslog

Discussion 0

Correct Answer: C Vote an answer

Question 8

A customer is using MetroCluster Tiebreaker software with Observer mode set to true. Tiebreaker just confirmed a disaster at one site. Which two steps must you perform to recover the service?
(Choose two.)

A. Open a case with the NetApp Support Site before executing any command on the system. B. Execute the metrocluster switchover-forced-on-disaster true command on the surviving site. C. Execute the metrocluster configuration-settings -switchover true command on the disaster site. D. Verify that the disaster site is down.

Discussion 0

Correct Answer: B,D Vote an answer

Question 9

Which component is responsible for managing site failover in an IP-based MetroCluster?

A. ATTO FibreBridge B. SnapMirror C. ONTAP Mediator D. SyncMirror

Discussion 0

Correct Answer: C Vote an answer

Network Appliance Implementation Engineer - MetroCluster - NS0-014 Exam Practice Test