NCP-NS by Nutanix Actual Free Exam Q&As

Question 1

Flow Network Security Next-Gen is supported in which two environments? (Choose two.)

A. On-Premises Overlay Networks B. NC2 Overlay Networks C. On-Premises VLAN Basic Networks D. NC2 VLAN Networks

Discussion 0

Correct Answer: A,B Vote an answer

Question 2

What does placing a policy in Monitor mode accomplish?

A. Enables hitlogs for traffic that matches the policy. B. Redirects discovered traffic to a monitoring device. C. Blocks traffic that does not match the policy. D. Visualizes discovered traffic that matches the policy.

Discussion 0

Correct Answer: D Vote an answer

Question 3

A customer wants to extend a VLAN subnet to a remote data center using VTEP. The administrator configures a Subnet Extension which shows UP in the Prism Interface, yet traffic fails to pass.
Which setting is most likely misconfigured?

A. Remote gateway IP address has not been configured. B. Route Policy for VTEP has not been configured. C. VXLAN UDP port is set to 4789. D. VLAN ID does not match in the remote data center.

Discussion 0

Correct Answer: D Vote an answer

Question 4

What is the role of the Network Controller in Flow Virtual Networking?

A. It manages configuration, monitoring, and optimization of network resources. B. Distribute the network traffic load across multiple guest VMs efficiently. C. It enables you to configure and manage common administrative tasks that are applicable to the platform and various Nutanix apps. D. It is used to create VPN, VTEP, or BGP gateways to connect subnets using VPN connections, Layer 2 subnet extensions over VPN or VTEP, or over BGP session.

Discussion 0

Correct Answer: A Vote an answer

Question 5

An administrator notices that several VMs in a Nutanix AHV cluster are intermittently losing network connectivity. In Prism Central, a critical alert appears:
"Network Function VM (NFVM) packet processing delays"
What is the next step that the administrator should take for this issue?

A. Reboot the affected VMs to re-establish virtual NIC connections. B. Increase the MTU size on all virtual switches to improve packet throughput. C. Review the Alerts and Events in Prism Central to confirm if the affected host shows NIC or uplink errors. D. Disable all Flow policies on the cluster to eliminate microsegmentation as the cause.

Discussion 0

Correct Answer: C Vote an answer

Question 6

An organization plans to apply security controls based on user group membership in Active Directory.
What configuration is required in Prism Central before VDI policies can be used?

A. Map category assignments to roles using RBAC settings. B. Configure category values mapped to AD groups. C. Create the list of users and assign categories to them. D. Assign categories to identities in the Admin Center.

Discussion 0

Correct Answer: B Vote an answer

Question 7

An administrator has a VPC with a single active gateway node that successfully peers with an external router using a single BGP GW and session.
To eliminate a single point of failure, the administrator deploys a second BGP gateway to the VPC. After the second gateway is added and shows a healthy state, the external router still only sees a single BGP session.
What is the most likely reason for the second session not being established on the external router?

A. The BGP Hold-down timer on the external router is set too high. B. The external router needs BGP peering configuration pointing to the IP address of the first gateway node. C. Network Security Groups are blocking BGP traffic from the second gateway's IP address. D. The second BGP gateway requires a BGP session configured to peer with the external router.

Discussion 0

Correct Answer: D Vote an answer

Nutanix Certified Professional Network & Security v6.10 - NCP-NS Exam Practice Test