JN0-130 by Juniper Actual Free Exam Q&As

Question 1

Which TCP port does LDP use for its protocol communications?

A. 466 B. 644 C. 464 D. 646

Discussion 0

Correct Answer: D Vote an answer

Question 2

If all OSPF routers on a broadcast network have the same OSPF priority, which parameter is used to determine the new BDR at the time of a DR failure?

A. loopback address B. IP address of interface on broadcast network C. router ID D. area ID

Discussion 0

Correct Answer: C Vote an answer

Question 3

Which configuration component is required to allow a PPP over ATM client to connect to one virtual router for a particular session and to a different virtual router for another session?

A. domain map B. static IP addressing C. IP access-route D. profile

Discussion 0

Correct Answer: D Vote an answer

Question 4

A Telnet user is authenticated using RADIUS and is provided Level 10 access. Which functions does this give the user?

A. all possible commands with the exception of support mode B. all possible commands including support mode C. only the disable, enable, exit,help, and all show commands D. only the disable,enable, exit, and help commands

Discussion 0

Correct Answer: A Vote an answer

Question 5

Where are Level 1 LSPs flooded?

A. over all Level 1 adjacencies B. over all Level 1 and Level 2 adjacencies within the IS-IS domain C. over all Level 1 and Level 2 adjacencies D. over all physical links

Discussion 0

Correct Answer: A Vote an answer

Question 6

How can you remove the Privileged Exec password from the router?

A. Configure erase secret 300 then push the top button on the SRP. B. Configure erase secret 60 then push the bottom button on the SRP. C. Configure erase secret 60 then push the top button on the SRP. D. Configure erase secret 300 then push the bottom button on the SRP.

Discussion 0

Correct Answer: B Vote an answer

Juniper networks Certified internet specialist.e(jncis-e) - JN0-130 Exam Practice Test