HPE6-A41 by HP Actual Free Exam Q&As

Question 1

Refer to the exhibit.

MSTP is implemented in the topology shown in the exhibit, and all the switches are in the same region. The network administrator does not want to use the Internal Spanning Tree (IST) or instance 0 for production traffic.
How many non-IST spanning tree instances does this network need in order to have effective load sharing on the uplinks from the access switches?

A. two B. five C. four D. three

Discussion 0

Correct Answer: C Vote an answer

Question 2

Refer to the exhibit.

MSTP is enabled on the switches shown in the exhibit.
Which additional step should the network administrator take to support load sharing of traffic on different switch-to-switch links?

A. Create an identical VLAN-to-instance mapping on each switch, in which some VLANs are in each instance. B. Configure different spanning tree port priorities for different instances on each access layer switch. C. Ensure that half of the switches use config revision 1 and half of the switches use config revision 2. D. Assign different spanning tree port costs to different instances on each access layer switch.

Discussion 0

Correct Answer: B Vote an answer

Question 3

A network administrator needs to configure a static route.
What should the administrator use as the next hop address?

A. the IP address of the default gateway in the destination subnet B. the lowest IP address on the neighboring router in the path towards its destination C. the IP address on the connected interface of a neighboring router in the path towards its destination D. the IP address on the local interface that is used to egress traffic towards its destination

Discussion 0

Correct Answer: C Vote an answer

Question 4

A network administrator wants to pre-configure new MSTP region settings on ArubaOS switches, and then apply the new settings at a later time. How can the administrator pre-configure the settings?

A. Change the MSTP region name after the new settings are configured. B. Use the pending option in the spanning-tree commands. C. Change the MSTP region revision number after the new settings are configured. D. Create a second spanning tree region on the switch and apply the settings to this region.

Discussion 0

Correct Answer: B Vote an answer

Question 5

Member1 is the commander of a Virtual Switching Framework (VSF) fabric. A power distribution causes member 1 to go down. Now the network administrator wants to rejoin member1 to the VSF fabric and make member1 the commander again.
What should the administrator do?

A. Configure member2 with VSF priority0. Then boot member1 and allow it to rejoin the VSF fabric. B. Boot member1 and allow it to rejoin to the VSF fabric. Then reboot member2. C. Boot member1 and allow it to rejoin the VSF fabric. D. Disconnect member1 from member2 before booting member1.

Discussion 0

Correct Answer: A Vote an answer

Question 6

A network administrator connects an Aruba Instant AP (IAP) to an ArubaOS switch but cannot connect the AP to the Instant cluster that exists. The administrator wants to check the IAP management IP address and software version from the ArubaOS switch CLI. To obtain this information, what should the administrator ensure is enabled on the switch and switch interfaces?

A. LLDP B. SNMP C. ARP D. Device profiles

Discussion 0

Correct Answer: A Vote an answer

Question 7

A network administrator wants to form a cluster with several Aruba Instant APs. What is required to achieve this goal?

A. All APs must be the same model. B. All APs must be in the same regulatory domain. C. All APs must operate on the same radio channel. D. All APs must be pre-configured with WLANs with the same SSID.

Discussion 0

Correct Answer: B Vote an answer

HP Aruba Certified Switching Associate - HPE6-A41 Exam Practice Test