HP0-P10 by HP Actual Free Exam Q&As

Question 1

After installing HP System Management Homepage (SMH) and restarting the system, how can you log in to the SMH?

A. Open a browser and enter: http://ip-address; then log in to the SMH page. B. Open a browser and enter: https://ip-address:2381; then log in to the SMH page. C. Start HP SMH from the system console and log in using your account information. D. You must log in locally, start SMH, and log in as Administrator.

Discussion 0

Correct Answer: B Vote an answer

Question 2

Fault management events can be viewed directly on a server as they occur. Which HP tool aggregates information from multiple systems in the data center?

A. OpenView Storage Area Manager (OVSAM) B. Systems Insight Manager (HP SIM) C. Event Monitoring Service (EMS) D. Offline Diagnostics Environment (ODE)

Discussion 0

Correct Answer: B Vote an answer

Question 3

Your HP Integrity server running Windows crashes with a blue screen. Which steps should you take?

A. Access the Management Processor (MP), enter CL to display the console log, then record the Stop Code. B. Record the Stop Code from the blue screen. Start the EFI Shell and enter errdump cpe. Record and verify the information. C. Record the Stop Code from the blue screen. After Windows reboots, check the System Event Log and the application logs. D. Access the Management Processor (MP) and enter tc to dump the system. After Windows reboots, check the dump information on the operating system.

Discussion 0

Correct Answer: C Vote an answer

Question 4

Where is the diskpart.efi utility located?

A. Red Hat Enterprise Server 3.0 64-Bit CD B. Windows Server 2003 Enterprise Edition boot CD C. HP Smart Setup CD D. HP OpenVMS v 8.2 boot CD

Discussion 0

Correct Answer: C Vote an answer

Question 5

You are managing an Integrity rx2620 server that is located in a remote office. Which Management Processor (MP) console command do you use to gather the state of the system and
LEDs?

A. VFP B. ERRDUMP C. SYSSTAT D. LED

Discussion 0

Correct Answer: A Vote an answer

Question 6

How can you use iLO 2 to display information about the physical location of an HP Integrity rx6600 server?

A. Log on to the iLO 2 MP. The information is displayed on the initial screen. B. Go to the System Status Tab in the GUI and select Asset Management. The information is in the Identification tab. C. Go to the Asset Management tab and click the Identification tab. D. Go to the System Status Tab in the GUI and select Server Status. The information is in the Identification tab.

Discussion 0

Correct Answer: D Vote an answer

Question 7

Which system boot start process will execute after the EFI and EFI extensions have been loaded?

A. load and run OS LOADER B. initialize hardware C. load and run the operating system D. execute System Abstraction Layer (SAL)

Discussion 0

Correct Answer: A Vote an answer

HP Integrity Server Multi-OS Installation and Deployment - HP0-P10 Exam Practice Test