Cisco Deploying Cisco Wireless Enterprise Networks - 300-365 Exam Practice Test
Which is the recommended maximum number of hop counts to support data clients on a wireless indoor mesh network?
Correct Answer: A
Vote an answer
Refer to the exhibit. To which setting is the client limitation for WLAN LAP1 configured?
Correct Answer: A
Vote an answer
An engineer enters theconfig wlan max-radio-clients 15 10command on the WLC that houses all auditorium APs. Which configuration is being implemented?
Correct Answer: D
Vote an answer
What devices can be tracked with the Cisco Context Aware Services?
Correct Answer: B
Vote an answer
You have just added a new MSE to Prime Infrastructure and want to synchronize the MSE with your 5508 WLC. which is located behind a firewall in a DMZ. You notice that NMSP messages are failing between the twodevices. What traffic needs to be allowed on the Firewall to ensure the MSE and WLC can communicate using NMSP?
Correct Answer: B
Vote an answer
An engineer must deploy FlexConnect APs to a site that typically has 300 ms latency to the WLC. Which typical operating mode must the engineer planon for normal operations?
Correct Answer: C
Vote an answer
An engineer has deployed two Cisco 2504 WLCs to support the wireless network in two newly added buildings on a campus. The engineer puts 70 APs in the first building on one WLC and 70 APs in the second building on the other Cisco 2504 WLC. Which result does this design achieve?
Correct Answer: D
Vote an answer
A network engineer must ensure that corporate wireless users have a better experience than guest wireless users. Which twoconfigurations fulfil requirement? (Choose two.)
Correct Answer: A,D
Vote an answer
How is password recovery performed on a Cisco Mobility Services Engine 3300 Series?
Correct Answer: D
Vote an answer
A customer has configured a wireless LAN controller and set the 802.11a/n data rates. All rates are enabled where 5.5 Mbps, 11Mbps, and 24 Mbps are set to Mandatory. What will APs send over the 24 Mbps data rate?
Correct Answer: A
Vote an answer
Which three fields are required when creating a new NetFlow Exporter? (Choose three.)
Correct Answer: B,C,F
Vote an answer
Where must a VLAN tag be present for the client to be placed on a specific interface using Cisco Identity Based Networking?
Correct Answer: D
Vote an answer
Which standard specifies TSPEC to provide the management link between higher QoS protocols and the channel access function?
Correct Answer: D
Vote an answer
An engineer must reduce the amount ofinter-controller roaming at a facility that has deployed N+1 high availability. Which strategy for performing this action is the best?
Correct Answer: D
Vote an answer
What is the maximum number of monitor reports that can be created by using Cisco AVC and Cisco Prime Infrastructure?
Correct Answer: B
Vote an answer